Off-roading

How to Install Vinyl

This may seems hard, but it is actually rather simple. Of course, this is coming from a sign guru. So lets start.

You will need:
Measuring tape, cleaning solution, rag or paper towel, masking or other tape, squeegee or credit card, and scissors.

  1. Clean the surface you are applying the vinyl to. I like alcohol and window cleaner, but the choice is up to you.
  2. Use the measuring tape to position the vinyl where you want it. Make sure it is centered and level.
  3. Tape the vinyl on both sides and down the center with about 2" on either side.
  4. Remove the tape on the left side and pull the masking, vinyl, and paper backing all the way back to the center piece of tape.
  5. Peel back the paper backing to reveal the sticky side of the mask and vinyl.
  6. Cut the paper backing, not the vinyl or mask, close to the center piece of tape.
  7. Starting at the middle and center, squeegee up, start at the middle and center and squeegee down. Start at the middle and squeegee up, start at the middle and squeegee down. Continue this motion until you are to the end of that half or side of the vinyl.
  8. Remove the center and right pieces of tape. Repeat step 7.
  9. Peel off the masking slowly, making sure the vinyl sticks.
  10. There is is! You have just applied vinyl.
  11. Send a picture of how great you did, so that I know this tutorial helps.
Fix jeep parts
Plans for my Jeep
Site Map
Email me at my jeep wrangler.com

Resources

Contact


©MyJeepWrangler.com 2003, 2004, 2005. You may not copy for any reason without permission. Jeep™ is a registered trademark. MyJeepWrangler.com has no affiliation with Jeep™.